The S9 VPAP AutoSet combines an intelligent algorithm with Easy-Breathe expiratory pressure relief (EPR) to dynamically adjust pressure for maximum comfort.
Using ResMed's time-tested APAP technology, AutoSet continually monitors breathing, adapting breath-by-breath to always deliver the lowest therapeutic pressure, improving comfort and sleep.
Enhanced AutoSet is now able to differentiate between obstructive and central sleep apneas, so you can be confident that you are always receiving appropriate therapy and pressure.
Operating pressure range 4 to 20 cm H2O Maximum single fault steady state pressure 30 cm H2O Pressure measurement tolerance ±0.5 cm H2O ± 4% of the measured reading Flow measurement tolerance ±6 L/min or 10% of reading, whichever is greater DECLARED DUAL-NUMBER NOISE EMISSION VALUES in accordance with ISO 4871: Sound pressure level 24 dBA as measured according to ISO 17510-1:2002 26 dBA with uncertainty of 2 dBA as measured according to ISO 17510-1:2007 Sound power level 34 dBA with uncertainty of 2 dBA as measured according to ISO 17510-1:2007 Nominal dimensions (L x W x H) 6.0 ″ x 5.5 ″ x 3.4 ″ (153 mm x 140 mm x 86 mm) Weight 1.8 lb (810 g) Housing construction Flame retardant engineering thermoplastic Supplemental oxygen Recommended maximum supplemental oxygen flow: 4 L/min Hypoallergenic air filter Non-woven acrylic and polypropylene fibers with polypropylene carrier Standard air filter Polyester fiber Air outlet The 22 mm conical air outlet complies with ISO 5356-1 Maximum heater plate temperature 150 °F (65 °C) Temperature cut-out 165 °F (74 °C) Maximum gas temperature = 106 °F (= 41 °C) Nominal dimensions (L x W x H) Docking station and water tub: 6.0 ″ x 5.7 ″ x 3.4 ″ (153 mm x 145 mm x 86 mm) Weight (water tub) Docking station and unfilled water tub 1.5 lb (0.67 kg) Weight (cleanable water tub) Docking station and unfilled water tub 1.7 lb (0.77 kg) Water capacity To maximum fill line 380 mL Docking station Flame retardant engineering thermoplastic, aluminium Cleanable water tub Injection molded plastic, stainless steel and silicone seal Water tub Injection molded plastic, aluminium and thermoplastic elastomer ClimateLine™ air tubing Flexible plastic and electrical components, 6 ′5 ″ (1.98 m), 15 mm inner diameter SlimLine™ air tubing Flexible plastic, 6 ′ (1.83 m), 15 mm inner diameter Standard air tubing Flexible plastic, 6 ′6 ″ (2 m), 19 mm inner diameter Heated tubing temperature cut-out = 106 °F (= 41 °C)
Notes: * The manufacturer reserves the right to change these specifications without notice. * The temperature and relative humidity settings displayed for ClimateLine™ are not measured values. * Check with your clinician/service provider before using the SlimLine™ air tubing with devices other than the S9 or H5i™.
Service & Support
Cleaning and maintenance You should regularly carry out cleaning and maintenance as described in this section. Daily 1. Disconnect the air tubing and hang it in a clean, dry place until next use. 2. Slide the H5i™ latch. 3. Lift open the flip lid and remove the water tub. 4. Wash the H5i™ water tub in warm water using a mild detergent. 5. Rinse thoroughly in clean water and allow it to dry away from direct sunlight. 6. Before next use, fill the water tub, return it to the H5i™ and close the flip lid. Note: Do not open the H5i™ water tub. There are no user serviceable parts inside.
The S9 system comprises the following elements: * S9 device * SlimLine™ air tubing * 90W power supply unit * S9 Travel bag * SD card * S9 SD card protective folder. Optional components include: * H5i™ heated humidifier * Standard air tubing * 30W power supply unit (does not support H5i™).
The manufacturer recommends that new patients purchase their devices, masks and initial accessories from a homecare company that can provide an individualized patient equipment setup, clinical and after-sales support, and a program to assist patients with therapy success.
CPAP Clinic meets this set of requirements by providing you with the following services:
at-home visit for personal assistance and training
unlimited toll-free telephone support before and after sale
unlimited email support before and after sale
appropriate CPAP and Auto-CPAP set-up according to prescribed pressure setting
I m writing to tell you how pleased I am that I found your store. Your prices are incredible and very competitive. Your free shipping offer is unbeatable! Your website is easy to navigate and placing an order is hassle-free. Your products are better than other brands that I have used in the past. I am happy to recommend cpaclinic.ca for anyone with sleep apnea
Alexander M Edmonton
I wrote to CPAP Clinic & asked them if they had the soft wraps for sale separately from the head gear on a ResMed swift FX. They didn t at the time, but soon had them for sale on line. Great service.
probably the best feed back, service, and quick delivery i have met
thanks for all anwar